Next Page. Summary of Contents for Genie 3 Button Remote Page 1: Remote Operation Any modi cations or changes to this equipment which are not expressly approved by the manufacturer Mt. Hope, Ohio could void the users authority to operate the equipment. Page 2 1 Door Drive distribudor local. Los cambios o modi caciones no aprobados expresamente por el fabricante podrian invalidar la Mt.
Hope, Ohio autoridad del usario de operar el equipo. Print page 1 Print document 2 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Installations using a Power Pak plug-in will connect the two terminals on the power pack to terminals 1 and 3 on the receiver, color coded white and red. This new Genie Intellicode Radio Receiver connects differently than previous versions of Genie external receivers.
The receiver is powered through the terminals marked power and common. A Genie garage door opener which has only 3 terminals on its motor head will use the terminals on the motor head marked 1 for common and 3 for power. If you have a Genie garage door opener with more than 3 terminals, an external 24Vac adaptor will need to be purchased to supply power to this receiver.
These are the same terminals which connect to your wall button. This small, black, unmarked button is located behind the light lens at the motor head and is nearest the floppy 6 inch antenna wire that protrudes from the motor head. When pressed, a radio signal indicator light will start blinking red for 30 seconds. Keep the transmitter you want tuned at least 2 feet away from the power head while tuning.
Press the transmitter button once more to test the system and start your door moving. Press and hold down the square button on the motor head until the round blue LED light come on, then release the square button.
The long purple LED button will start to blink. Note: if the blue light stays on, go to instructions for Intellicode III, below While the long LED is blinking, hold the remote 4 or 5 feet away and press 3, 4 or 5 times, until the door activates. Your remote is now programmed.
Press the square button once more until the long purple LED comes on and release. The purple LED should be blinking. To unlock the programming feature use a remote that already operates the unit and press it once. A video with step-by-step instructions can be found here. PDF Instructions found here. Locate the Genie garage door opener learn button. The red LED will begin to flash. Note: While programming remote buttons, stand at least 5 feet away from the opener.
This ensures you have proper communication between the remote and the opener. Slowly press and release the remote button of your choice two times. The opener LEDs will flash and go off, indicating you have successfully programmed your remote. Press and release the same button a third time and door will open or close.
It is possible to press the remote button too quickly or lightly. Your opener will no longer recognize any signal from any remote device, including a missing remote device. NOTE: For openers manufactured between , use the two upper buttons on the remote. Made after - use any button for programming.
Jazmine — Please contact our customer service line at so we can troubleshoot with you. I had a genie garage door opener installed yesterday.
0コメント